Peer Knowledge Base
Peer Knowledge Base
Breadcrumbs

Cannot see the PeerSync Profiler Display

The most common cause of no display in the Profiler is that mail slots are not working properly and it is usually due to the Local Area Connection’s NetBIOS Settings.

  1. Go to Control Panel > Network and Sharing Center.

  2. Click View Status to the right of the Local Area Connection.

  3. Click Properties.

  4. Select Internet Protocol Version 4 (TCP/IPv4) and click Properties.

  5. Select Advanced.

  6. Select the Default or Enable option under NetBIOS setting (WINS tab). This signifies that NetBIOS is enabled.

  7. Select OK and close out all windows to apply the change if it was needed.

Page: Cannot see the PeerSync Profiler Display Page: Create a Profile Page: Distribute a PeerSync Profile to other machines on a network Page: Find all the configuration options of the PeerSync software Page: Link an existing PeerSync configuration with the PMC Page: Move a PeerSync configuration to a new server Page: Set up PeerSync to run as a service Page: Set up real-time bi-directional synchronization Page: Supported predefined variables